Abstract:
The grinding cost of metal matrix composite materials is more due to low removal rates and high rates of wear of super abrasive wheels. This electrolytic in-process dressing (ELID) technique uses a metal-bonded grinding wheel that is electrolytically dressed during the grinding process for abrasives that protrude continuously from super abrasive wheels. This research carries out ELID grinding using various current duty ratios and conventional grinding of 10% SiC(p) reinforced 2,124 aluminium composite materials. Normal forces and tangential forces are monitored. Surface roughness of the ground surface, Vickers hardness numbers and metal removal rate (MRR) are measured. The results show that the cutting forces in the ELID grinding are unstable throughout the grinding process due to the breakage of an insulating layer formed on the surface of grinding wheel and are less than conventional grinding forces. A smoother surface can be obtained at high current duty ratio in ELID grinding. The micro-hardness is reduced at high current duty ratio. In ELID, the MRR increases at high current duty ratio. The results of this investigation are presented in this paper.
